Ikonart Release Sheets Pack 10 | Protects Stencil Adhesive | 11x14"/ 279x355mm | Use for Storage
Protects Stencil Film adhesive after use/ for storage.
Ikonart USASKU: E-RS10
In Stock
Protects Stencil Film Adhesive
After using your Ikonart/ EZIscreen Stencil Film (with an adhesive backing) you can return them to the clear carrier sheet that they came on . . . . however if you lose or damage it, forgot to mark the back, or just want the backing sheet to be larger than your Stencil Film then protect the adhesive on your Stencils with these larger Ikonart Release Sheets.
Large 11x14" size is larger than Ikonart 10x12" and EZIscreen 8.5x11" Films.
- Combine 2 sheets for Ikonart XL 12x18" Stencil Film
Silicone treated sheets can be cut to customs sizes for smaller Stencils and storage.
Note: Standard pack is 50 Sheets, this is a refill pack supplied in clear plastic bag, bag pictured is for illustration purpose only.
How to use
After using your Stencil Film, wash off the paint/ paste/ ink to leave a clean surface design area. You can use a foam brush or soft brush on the front side of your stencils to remove excess paint. Do not rub or scrub the adhesive side of your stencil. We do not recommend using any chemicals to clean the stencils, as this can break down the emulsion coating.
After you wash your Stencil you can return it to the original clear carrier sheet or you can use one of these Ikonart Release Sheets as a new backer sheet.
Place the adhesive side of your Stencil on the silicone (slippery) side of a Release Sheet while the stencil is still wet. Let the stencil dry on a flat surface.
Film Cleaning & Storage
Store your Stencil Film flat in a dry area.
Quick video showing how to use the Release Sheets with your Ikonart/ EZIscreen Films.
Don't Soak Films
Remember less water for washout is better with Ikonart/ EZIscreen. Unlink the previous systems using StencilPro film (now discontinued), which required a 10minute water soaking prior to washout, the new films must not be soaked, sprayed only.
| SKU | E-RS10 |
| Barcode # | 9334315037644 |
| Brand | Ikonart USA |
| Shipping Weight | 0.1500kg |
| Shipping Width | 0.365m |
| Shipping Height | 0.010m |
| Shipping Length | 0.295m |
| Shipping Cubic | 0.001076750m3 |
| Unit Of Measure | Pack |
| Type | Made in USA |
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law (ACL). You are entitled to a replacement or refund for a major failure. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Should you receive a product that does not meet your expectations, you may immediately return it for a refund or exchange - prior to opening or using the product.
Where products have been opened or used, suitability of usage has been determined and no refund is available for change of mind purchases on used products. This does not exclude warranty claims where product may be faulty or contain a manufacturing fault.
